Types of Deck Flashing

The IRC code requires that you install approved corrosion-resistant flashing in a shingle fashion to prevent water going into the wall cavity. The flashing shall extend to the surface of the exterior wall finish.

Corrosion resistance is defined as the ability of a material to withstand deteriorization of its surface or properties when exposed to its environment.

Deck flashing creates a barrier to prevent moisture from entering the house in the openings you create when attaching your ledger board connection.

You can buy flashing either in roll form or in rigid Z- or L-shaped 10' sheets made of stainless steel, copper or vinyl material. Never use galvanized steel or aluminum flashing in contact with an ACQ pressure-treated wood ledger board because it will corrode. Vinyl flashing is the least expensive option, but it may not work as well in areas with extreme temperature fluctuations. If you are installing copper flashing from a roll, make sure you use copper nails to secure it into place to prevent corrosion. Copper works well because it is compatible with the chemicals used in commonly sold ACQ-treated lumber and is easy to bend. Because flashing comes in different widths, make sure your flashing will be the right size to tuck up behind the house siding at least a couple of inches. We recommend that you install a bead of silicone caulk to fill any openings.

Save

Cut the flashing with tin snips

Our White Vinyl Roll Flashing is made of exterior-grade polyvinyl chloride for use with all pressure-treated lumber.

Save

Nail the flashing onto the house.

Z Flashing tucks under the siding and wraps over the top of the ledger board.